Skip to content
GET A FREE CTA T-SHIRT WHEN YOU SPEND $200! Add T-Shirt to cart to receive automatic discount.
GET A FREE CTA T-SHIRT WHEN YOU SPEND $200! Add T-Shirt to cart to receive automatic discount.
4036 - Coil Spring Compressor - External

4036 - Coil Spring Compressor - External

SKU 4036
$94.95 - $94.95
$94.95
$94.95 - $94.95
$94.95

Orders placed before 12:00pm EST Mon-Fri ship same day. Orders placed after 12:00pm EST ship next business day.

  • Removes and installs coil springs where removal through the center of the spring is not possible
  • Services both Straight & Curved Coil Springs
  • Includes S-bolts & wing nuts
  • Maximum diameter spring that the hooks will accommodate is 0.75".
  • Diameter of the rod: 5/8"

INSTRUCTIONS FOR STRAIGHT COIL SPRINGS:

  1. Install 3 leg assemblies evenly around the spring. Turn nuts finger-tight to hold in position.
  2. Install one S-bolt near the center of each leg with open end pointing away from the spring. Place the bar and wing nuts on the S-bolt, then finger-tighten the wing nuts.
  3. Tighten each leg nut a little at a time to compress spring gradually. Do not over-compress.
  4. To release the compressor, loosen each leg nut a little at a time.

INSTRUCTIONS FOR CURVED COIL SPRINGS:

  1. With the car raised and safely supported, place a jack under the lower control arm. Raising the jack will compress the spring.
  2. Install as many leg assemblies and safety S-bolts as possible (see #1 & #2 above), then finger-tighten the leg nuts.
  3. Disconnect the lower control arm bolts, then slowly lower the jack until the spring can be removed. The curved contour will remain.
  4. To install a new coil spring, use one or more legs and S-bolts to produce the necessary curve.

NOTE: Keep the threaded portion of the legs clean and well greased.
Interchange
  • Removes and installs coil springs where removal through the center of the spring is not possible
  • Services both Straight & Curved Coil Springs
  • Includes S-bolts & wing nuts
  • Maximum diameter spring that the hooks will accommodate is 0.75".
  • Diameter of the rod: 5/8"

INSTRUCTIONS FOR STRAIGHT COIL SPRINGS:

  1. Install 3 leg assemblies evenly around the spring. Turn nuts finger-tight to hold in position.
  2. Install one S-bolt near the center of each leg with open end pointing away from the spring. Place the bar and wing nuts on the S-bolt, then finger-tighten the wing nuts.
  3. Tighten each leg nut a little at a time to compress spring gradually. Do not over-compress.
  4. To release the compressor, loosen each leg nut a little at a time.

INSTRUCTIONS FOR CURVED COIL SPRINGS:

  1. With the car raised and safely supported, place a jack under the lower control arm. Raising the jack will compress the spring.
  2. Install as many leg assemblies and safety S-bolts as possible (see #1 & #2 above), then finger-tighten the leg nuts.
  3. Disconnect the lower control arm bolts, then slowly lower the jack until the spring can be removed. The curved contour will remain.
  4. To install a new coil spring, use one or more legs and S-bolts to produce the necessary curve.

NOTE: Keep the threaded portion of the legs clean and well greased.
PP-DEBUG: Current path: /products/4036